For One Gel solid colors, each layer applied should be thin. One layer will provide you with a full, flawless coverage, however you may apply a second coat if you desire extra opacity. When using One Gel Magnetic, be sure to only apply one layer, thicker than you would for color, before activating the effects with the magnet tool.

No, all One Gel Products must be cured with the One Gel lamp, as any lesser wattage will not fully cure the gel, leaving the polish dull and gummy.

Blot a thick layer of our NEW One Gel Magic Off onto nails. After 3 minutes, the remover will begin activating, however you may experience best results by waiting 5-7 minutes. Once gel begins to bubble off, use the included tool to push gel off nails. Repeat until all gel is removed.

For removal, please note that One Gel is only compatible with our One Gel Magic Off. Magic Off+ is not designed to remove One Gel and may cause further damage if paired with the attempt to force polish off nails.

If you’ve applied our Gel Top Coat over One Gel, be sure to buff the surface of your nails to disrupt the outer layer, allowing Magic Off to reach and remove the gel polish.

Experiencing a slight tingling sensation while using Magic Off is normal! If this feeling becomes too uncomfortable, run your nails under cold water and wipe the remaining product off your skin. Avoid contact with the cuticle & surrounding skin, focusing the remover exclusively on your nail beds to prevent any reaction.

All One Gel polishes do currently contain HEMA, however, we are working to develop a HEMA-free version in the future!

If you’re experiencing premature chipping, be sure to cap your free edge to help seal the edges of your manicure/pedicure. For a visual of how to do so, see the following tutorial.

Yes! You can, but you definitely don't need to. We created this top coat to enhance the shine and durability of all our products, allowing you to achieve the best & longest-wearing mani/pedi possible!

That tool is a dual-sided cuticle pusher/gel remover. The curved end is meant to push back outgrown cuticles, while the sharper end can be used to remove the bits of gel that need a little extra push.

This is a 10W lamp, so it’s very important that you use it to cure One Gel. Any lesser wattage will not fully cure your mani and it will soon become a mess!

Yes! The One Gel LED Lamp is compatible with both GLAZE and One Gel products.

There are multiple ways to use it, actually. We can show you easier than we can tell you, so check out these tutorials to see how it's done!