Don't miss out!
Buy Any 3 Products* and Get a FREE GLAZE Mystery Mani!
Use code: MYSTERY
We will send you an email to reset your password.
We will send you an email to reset your password.
• Thinner cuticle edge for a natural, seamless appearance.
• Damage-free removal with use of Magic Off+ Remover.
• Cushioned gel glue technology for maximum comfort.
• Easy, no soak-off removal for healthier nails.
• Easier-than-ever nail extension application.
• Pre-buffed nails for superior adhesion.
• Pre-designed with pro-level nail art.
• Sculpted to look like your real nails.
• Superior wear for up to 14 days!.
• No primer or bonder needed.
30 nails, 1 max comfort soft gel glue (5g), 1 mini dual-sided file and buffer, 1 prep pad
STEP 1: PREP
Remove any polish before beginning nail prep.
Trim and file nails (white side of file).
Wash hands and use prep pad to clean & dehydrate nail beds.
Lightly buff nail beds (pink side of file).
Push back cuticles using wooden manicure stick.
STEP 2: APPLY
Select nail tips for each nail. If in between sizes, size down or file a larger nail tip to fit.
Evenly spread a thin layer of soft gel glue to the bottom half of the pre-buffed (matte) section of the nail tip.
When applying to your nail, hold artificial nail between top of the nail tip and the number tab.
Apply nail tip from cuticle line to free edge to spread glue evenly, without releasing just yet.
PRO TIP: If the glue does not fill the entire nail or if air bubbles have occurred, remove nail tip, apply more glue, and readjust.
STEP 3: CURE
Keep pressure on the nail tip & cure under the GelXtend LED lamp for 60 seconds.*
To keep the light on, ensure your finger stays in contact with the sensor.
*Lamp will automatically turn off after 60 seconds.
PRO TIP: For opaque design nails, cure upside down for 60 seconds to ensure the light reaches glue.
PRO TIP: Rotate the lamp as needed for an easier application process and tightly fasten the cap for the Max Comfort Super Gel Glue to prevent from drying out.
Nails: ABS Plastic
Prep Pad: Isopropyl Alcohol, Water
Glue: Polyurethane Acrylate, Isobornyl Acetate, Hydroxypropyl Methacrylate, Benzoyl Isopropanol, Dimethicone
Adding product to your cart
There could be a few reasons behind that, so here are the most common reasons and some tips to help!
PREP: Make sure you are pushing back your cuticles and buffing with a rough buffer (included), not one that smooths your nail.
The last step of prep should be wiping your nails with the included alcohol prep pad.
GLUE APPLICATION: The right amount of glue, with no flooding around the edges, is so, so important; too much glue is just as bad as too little glue.
YOU AREN’T CURING LONG ENOUGH: Make sure all sides are secure by curing the entire hand again for 60 seconds, to make sure the glue is fully hardened.
NAIL APPLICATION: Do not move while holding the nail as you’re curing, as this could cause bubbles.
This process could have a learning curve for sure! But the perfect amount of glue is dependent on the size of your nail bed.
PRO TIPS: Apply glue to the bottom 1/3 of the pre-buffed area of the nail, a little bit above the cuticle edge .
Do not press so hard when applying the nail tip; stop right when the glue reaches your natural nail edge.
If the glue does not cover your entire nail bed or you see bubbles, take off the nail and apply more before curing.
Clear nails only need 60 seconds to cure, but the sheer design nails must be cured at least 2x. If you feel you used a thick layer of glue with a clear nail tip, we recommend curing twice to make sure the glue is fully hardened all the way through.